Delcam’s PartMaker Division has released PartMaker 2014, which marks the introduction of Delcam’s Vortex high-efficiency strategy for area clearance into the PartMaker CAM suite.
Vortex is Delcam’s newest proprietary high-speed roughing technology. Vortex controls the maximum engagement angle of the cutter in the material, such that the angle calculated for the programmed stepover is never exceeded, even in internal corners. This allows for optimal cutting conditions to be maintained throughout the toolpath.
Deeper cuts…
By controlling the maximum engagement angle and the load on the tool, Vortex can take deeper cuts than traditionally used in roughing operations. Depths of cut up to the full flute length enable maximum material removal rate from solid carbide tooling and reduce machining times by up to 70%. Vortex is available as a free upgrade to licensees of PartMaker’s Advanced Surface Machining (ASM) module that are on maintenance.
Back turning tools… PartMaker 2014 includes improved functionality to support the automated programming of back-turning tools. These tools are used across a wide variety of small-part turning applications, particularly in Swiss machining. With their unique geometry and cutting characteristics, back-turning tools can eliminate the need for multiple tools and so can reduce cycle time and improve surface finish.
..and other enhancements The new version also presents many other enhancements, for example:
- 2D pocketing. This more powerful functionality allows for more efficient and intelligent material removal from 2D pockets.
- The raster finishing strategy in PartMaker ASM has also been enhanced, resulting in less fragmented toolpaths without overlaps when machining highly complex shapes, thus improving part surface finish.
- …and much more!
For further information on Delcam’s PartMaker CAM software, please go to .
.
.
...brought to you by Eurotec-Online.com
